ABC of Safety in the Biological Sciences

 


 

SODIUM SULPHATE (Na2SO4)

SYNONYMS
Glauber's salts.
GENERAL PRECAUTIONS
Avoid eye contact.
Avoid inhalation or ingestion.
Keep away from moisture.
Keep the container tightly sealed.
Wash hands thoroughly after handling.
CHARACTERISTICS
Hygroscopic, colourless crystalline granules or white powder.
HEALTH HAZARD DATA
Sodium sulphate is mildly toxic and an eye and respiratory tract irritant. In the presence of water it is corrosive.
TREATMENTS
Skin ­ immediately remove contaminated clothing and wash the affected area with soap or mild detergent and large amounts of water until all evidence of the chemical has been removed (approximately 15 minutes). Wash contaminated clothing before re­use.
Eyes ­ immediately wash the affected eye with large amounts of water until all evidence of the chemical has been removed (approximately 15 minutes). If irritation or pain persist seek medical attention.
Inhalation ­ remove from the area of exposure to fresh air. If breathing has ceased apply artificial respiration. Keep warm and allow to rest. If irritation persists or develops seek medical attention.
Ingestion ­ wash out the mouth thoroughly with water and give water to drink. Seek immediate medical advice.
INCOMPATIBILITY
None known.
STORAGE
Store in a cool, dry atmosphere away from moisture. Keep the container tightly closed.
HANDLING
Wear protective clothing. A long sleeved laboratory coat or gown, rubber gloves, safety goggles and a face mask as a minimum standard.
DISPOSAL
WEAR:
Rubber gloves, safety glasses and laboratory coat.
SPILLS:
Solid: collect in a beaker, dissolve in a large amount of water. Add soda ash, mix and neutralise with 6M hydrochloric acid and discharge to sewer with large excess of water.
Solution: cover with soda ash, mix and scoop into a beaker of water. Neutralise with 6M hydrochloric acid and discharge to sewer with a large excess of water. If a spill contains a fluoride, add slaked lime in addition to the above treatment.
PACKAGE LOTS:
Add slowly to a large container of water. Stir in a slight excess of soda ash. If fluoride is present add slaked lime. Let stand for 24 hours. Decant or siphon into another container and neutralise with 6M hydrochloric acid. Discharge to sewer with a large excess of water. The sludge may be added to land fill.
ENVIRONMENT:

 


BACK to the top of the Glossary Contents List
BACK to the top of the Chemical Contents List

REFERENCES